|
Post by Cluemeister on Oct 22, 2017 22:51:49 GMT
Garmin said my servos were not in the "bad batch", so they sent me just the replacement pitch servo. Charged me for the new one and then they will credit me when I return the original.
|
|
alan
New Member
Posts: 6
Home Airport: KPWK
|
Post by alan on Oct 1, 2020 23:22:47 GMT
Quick question how do you go about removing the center console on the P2008. I removed the 4 screws on the rear of the center console only to find that that is just an end plate and not secured to anything else.
Thanks-Alan
|
|
|
Post by Ed Midgley on Oct 2, 2020 21:34:20 GMT
Remove the seats Remove the pans under the seats Remove the screws that connect the console to the floor Remove the screws at the front of the console Unscrew the phone and mike jacks from the rear of the console Lift the console from the rear first and reach under and unplug the wires to the power outlet After you do it a few times it can be done in twenty minutes Going back together it’s easy to strip the screws going into the floor as they just screw into the carbon fiber If you have to you can go to a larger screw The console does have to be removed in order to remove the pitch servo.
Ed
|
|
alan
New Member
Posts: 6
Home Airport: KPWK
|
Post by alan on Oct 3, 2020 16:36:59 GMT
Remove the seats Remove the pans under the seats Remove the screws that connect the console to the floor Remove the screws at the front of the console Unscrew the phone and mike jacks from the rear of the console Lift the console from the rear first and reach under and unplug the wires to the power outlet After you do it a few times it can be done in twenty minutes Going back together it’s easy to strip the screws going into the floor as they just screw into the carbon fiber If you have to you can go to a larger screw The console does have to be removed in order to remove the pitch servo. Ed Thanks a million Ed. Much appreciated.
|
|
Anton
New Member
Posts: 1
Home Airport: UNNM
|
Post by Anton on Nov 25, 2020 7:37:49 GMT
Hello, Everybody!
Did you make any pictures of your servo? How it's located and fixed?
I've bought P2008 with dual Dynon D1000 installed. But there is no servo. And i really want to have an autopilot. According to Dynon manuals I need only to install servo - all other installed systems are enought for an autopilot functions.
I'm allowed to make almost any changes to my P2008 because in Russia it's almost in Experimental category :-)
Thank you in Advance! /Anton
|
|